0 W N E R' S G U I D E
remote for 3 seconds. The remote plays the remote start shut off tones and the orange LED flashes 1 time. The vehicle shuts down from the remote
Valet Take-Over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is
Prog£omming options Programming options control your system's normal operational set-up. Most options do not require additional parts, but
~ Quick Reference Guide To remote start the vehicle • Press and release the transmitter button for 1-second. The re-mote responds with the rem
Limited lifetime consumer wo[[ooty Directed Electronics. ("Directed") promises to the original purchaser to repair or replace (at Directed&a
WITHOUT LIMITATION, LIABILITY FOR THEFT, DAMAGE AND/OR VANDALISM. THIS WARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REINSTALLATION
driven to excel Z'~ard· E L E C T R 0 N I C S Vista, CA 92081 www.viper.com © 2011 Directed Electronics. All rights reserved. Directed Elect
Quick Reference Install Guide Remote Start with Keyless Entry 4203-series 1-button remote-2-way Wiring Connections Heavy Gauge Relay Side View ions __
Contents Government Regulations ... 2 Warning! Safety first ...
PllllJIOmming System Features The System Features learn Routine dictates how the unit operates It is possible to access and change most of the feat
VEHICLE EQUIPPED WITH A DEl® REMOTE START SYSTEM If vehicle battery is disconnected, the system may attempt to start when the battery is reconnected o
Please send products and other correspondence to: Directed 1 Viper Way Vista, CA 92081 XFR01-01 DIRECTED® PO BOX 174391 DENVER CO 80217-4391 First-Cla
IMPORTANT! IMPORTANT! D I RE CTE D Please complete and return within the next 10 days ® or register online at productregister.com/directed. 1. 1. 0 Mr
This product is cC>,ie.rE~d by one or more of the following U.S. patents: 303,223 340,000 3.52,685 4,38),2~1. 4,8-1,63G 5, ltJ, 141 5,534,845 5,79
Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol-lowing two conditions: ( 1) This device may no
A Warning! Safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this produc
to have him or her test the remote start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when
What is Included • The control module • Two 1-button transmitters (P /N 721 1 V) • A push-button programming switch • Your warranty card • A shut-
BaHery Replacement 1 . Using a small slotted screw-driver, insert into slot located on the side of the unit as shown and carefully pry the fr
Using Your System Unlocking Only after the vehicle is remotely started via the transmitter, press and release the transmitter button for 1 second to
Note: In order for the ignition controlled door locks to work, the feature must be turned on in programming. Note: If the ignition is turned on while
Comments to this Manuals