Viper 5500 Installation Guide download pdf (Page 27)

NOTE: If the remote start is on the parking lights will turn off then flash

2-times before returning to their normal output and the defogger out-

put, if active, will cease.

To turn the rear defogger output ON:

1. Simultaneously press & release the + + but-

tons on the remote control.

2. The lights will flash 3 times.

3. The rear defogger output will once again activate when the

vehicle is remote started.

NOTE: If the remote start is on the lights will turn off then flash 3-times

before returning to their normal output and the defogger output will

activate as programmed.

The Valet Take-Over feature allows the vehicle to remain running

after the key has been removed from the ignition. This feature is

useful for occasions when you wish to exit and lock the vehicle for

short periods of time, but would like to leave the motor running

and the climate controls on.

To perform Valet Take-Over:

1. Before turning off the engine, press and release on the

transmitter twice (or press and release the optional momen-

tary switch twice).

2. Turn the ignition key to the OFF position. (The engine will

stay running.)

3. The engine will run until the pre-programmed time elapses or

Valet Take-Over

1 ... 26 27 28 ... 37

No comments

Viper 5500 Installation Guide Page 27