Viper 330V Installation Guide download pdf (Page 27)

NNOOTTEE::

If the Unlock learn was unsuccessful, the Unlock procedure can be repeated

by using the LOCK learn procedure, except that at step 4 press and release the Valet

button TWICE. (The LED will flash in groups of two flashes.)

to exit the learn routine:

Do one of the following:

Turn the ignition on.

No activity for longer than 15 seconds.

Press the Valet

button too many times.

on-board dual stage shock sensor

There is a dual-stage shock sensor inside the control module. Adjustments are made via

the rotary control as indicated above. Since the shock sensor does not work well when

mounted firmly to metal, we recommend against screwing down the control module. The

full trigger of the onboard shock sensor reports zone 2. See Table of Zones.

NNOOTTEE::

When adjusting the sensor, it must be in the same mounting location that it will

be after the install is completed. Adjusting the sensor and then relocating the module

requires readjustment.

Less Sensitive

More Sensitive

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 42 43

No comments

Viper 330V Installation Guide Page 27