Viper 771XV Installation Guide download pdf (Page 16)

Page notification

The remote control can be programmed to notify the user of a

page (audibly beeping if the vehicle’s status changes, e.g. door

unlocked, engine started, vehicle violation, etc.). Press to

select page On/Off. One beep is page On, Two beeps is page Off.

When programmed off the remote will not give any notification

that a page was received from the vehicle.

To exit programming mode

The remote control will exit programming mode after 2-seconds

of inactivity and will emit 2 long beeps.

uussiinngg yyoouurr ssyysstteemm

warning! safety first

The following safety warnings must be observed at all times:

➤ Due to the complexity of this system, installation of this

product must only be performed by an authorized Directed

dealer.

➤ When properly installed, this system can start the vehicle via

a command signal from the 2-way remote control. Therefore,

never operate the system in an enclosed area or partially

enclosed area without ventilation (such as a garage). When

parking in an enclosed or partially enclosed area or when

having the vehicle serviced, the remote start system must be

disabled using the installed toggle switch. It is the user's sole

responsibility to properly handle and keep out of reach from

children all 2-way remotes to assure that the system does not

unintentionally remote start the vehicle.

TTHHEE UUSSEERR MMUUSSTT

➜

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

No comments

Viper 771XV Installation Guide Page 16