Viper 3105V Installation Guide download pdf (Page 14)

Important! To achieve the best possible range, DO NOT leave the

control center cable bundled under the dash. Always extend the cable

full length during installation, regardless of the antenna mounting

location

CONTROL CENTER CABLE

CONTROL

CENTER

On-Board Dual-Stage Shock Sensor

There is a dual-stage shock sensor inside the control unit. Adjustments are

made via the rotary control as indicated in the diagram. Since the shock sensor

does not work well when mounted firmly to metal, we do not recommend

screwing down the control module. The full trigger of the on-board shock

sensor reports Zone 2. (See Table of Zones section of this guide.)

Note: When adjusting the sensor, it must be in the same mounting location

that it will be after the installation is completed. Adjusting the sensor and then

relocating the module requires readjustment.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

Viper 3105V Installation Guide Page 14