© 2008 Directed Electronics- All rights reserved.
16
Programming Jumper
Light Flash Jumper
This jumper is used to determine the light flash output. In the (+) position,
the on-board relay is enabled and the unit will output (+)12V on the WHITE
wire, H1/2. In the (-) position, the on-board relay is disabled. The WHITE
wire, H1/2, will supply a 200 mA (-) output suitable for driving factory
parking light relays.
NOTE: For parking light circuits that draw 10 amps or more, the jumper must
be switched to a (-) light flash output. P/N 8617 or a standard automotive
SPDT relay must be used on the H1/2 light flash output harness wire.
Important! DO NOT connect the H1/2 light flash wire to
a negative vehicle light flash wire before changing the
programming jumper to the negative polarity position or
damage to vehicle light circuit may occur.
Comments to this Manuals