Viper 3105V Instruction Manual download pdf (Page 19)

Arming diagnostics

If the system is armed while an input is active - door open, sensor

triggering - the unit chirps once when arming and then one more time

a few seconds later. This is called Bypass Notiﬁcation.

Bypass Notiﬁcation does not occur when using Silent Mode or if

chirps have been programmed OFF. The security system continually

ignores the zone that was active until the input stops. Three seconds

after the input stops, the system monitors that input normally.

For example, if your vehicle has interior light exit delay and you arm

it before the interior light goes out, you may hear Bypass Notiﬁcation

chirps. Once the light shuts off, the doors are mon i tored normally.

Disarming diagnostics

Extra disarm chirps are the Tamper Alert. If four chirps are heard when

disarming, the system was triggered in your absence. If ﬁve chirps

are heard, a zone was triggered so many times that Nui sance Pre-

vention® Circuitry has bypassed that zone (see NPC section of this

guide).

The in-vehicle status LED indicates which zone was involved. (See

Table of Zones section of this guide.) The system retains this informa-

tion in its memory, and continues to chirp four or ﬁve times each time it

is disarmed, until the next time the ignition key is turned on.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 40 41

No comments

Viper 3105V Instruction Manual Page 19