Viper 3105V Instruction Manual download pdf (Page 24)

Disarming the VRS

Take the time to familiarize yourself with the VRS trig ger ing se quence

and the disarm pro ce dure. It is important to recognize and identify the

VRS trigger sequence and know how to disarm it in case of ac ci den-

tal activation.

Once the VRS is armed, it does not disarm au to mat i cal ly. You must

disarm it the next time you operate the vehicle. You must dis arm it with

one of the fol low ing pro ce dures:

If the system has not entered the triggered sequence (siren has not

started chirping):

1. Turn the ignition on.

2. Press

on the remote control for 1 second. The lights ﬂash

and the siren chips. If the system has entered the triggered se-

quence (siren has begun chirping), pressing the disarm button of

the trans mit ter will not disarm VRS.

To disarm the VRS during a VRS trigger sequence:

3. Turn the ignition on.

4. Press the Valet button the pre-programmed number of times to

disarm the VRS system.

If the VRS has begun its chirping sequence, the ignition must be

turned off, then On, to disarm. If you are driving the vehicle, pull

over to a safe place and follow the triggered sequence disarm

procedure.

Note: The unit responds to 1 to 5 valet button presses to disarm

the VRS (factory setting is 1 press). Check with your installer to

determine the setting you want.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 40 41

No comments

Viper 3105V Instruction Manual Page 24