Viper 2.08 Specifications download pdf (Page 253)

100

101

243

Manual # 016-0159-894 Rev H 01/07

8 - Viper Guidance

5. Press Swath + to move to the inside of the field when you have

completed the next swath path. Press Swath - to move to the out-

side of the field when you have completed the next swath path.

Helpful Hint: You must press Swath + after each swath

path through the field in order to initiate guidance for the

next swath path through the field.

One Step

The One Step pattern allows you to set a swathing pattern that is based on a

straight back and forth pattern.

Setting the One Step Pattern

During the job setup, select One Step as the swath pattern.

Once the job is started:

1. Drive in the direction of the reference swath path and press Set A.

Viper sets the starting mark to the current position of the vehicle and

sets the ending mark ahead by four swath widths in the direction of

the current course over ground direction.

2. Drive the reference swath path. If offset errors display, press

Set B. Viper resets the end mark.

3. When you have finished driving the reference swath path, turn

towards the second swath path and continue with the snap-to-swath

path.

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 341 342

Comments to this Manuals

No comments

Viper 2.08 Specifications Page 253

Comments to this Manuals