Viper 2.08 Specifications download pdf (Page 85)

Manual # 016-0159-894 Rev H 01/07

3-Navigating the

Viper Interface

Autoboom Status Indicator

The status of the AutoBoom controller displays in this area.

This section will display only if an Autoboom controller has been detected. This

section displays “calibration required” if the AutoBoom system has not been cali-

brated. This section displays “Autoboom OFF” if Autoboom is turned off. This

section displays “Autoboom Offline” if Autoboom was originally detected but is not

responding to commands.

The center of this section displays “Autoboom” if the AutoBoom controller is a

PowerGlide Plus. The center section displays “BmHt” and the desired set height, in

inches, if the Autoboom controller is an UltraGlide.

The right and left sides of this section display the status of the right and left Autoboom

control. If a gray “A” is displayed, then the right or left boom section control is on

but not engaged. If the “A” display is green, then the right or left boom section

control is on and engaged. If the area behind the “A” is white, then the status of the

AutoBoom control is good. If the area behind the “A” is red, then an error condition

is present on that boom section.

Pressing the center of the Autoboom status indicator displays the Autoboom control

screen. Two different screens are possible depending upon the Autoboom in use.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 341 342

No comments

Viper 2.08 Specifications Page 85