Viper 2.08 Specifications download pdf (Page 255)

245

Manual # 016-0159-894 Rev H 01/07

8 - Viper Guidance

Headlands with Contour

The Headlands with Contour pattern allows you to set a contoured swathing

pattern for a field that has a headlands area around the boundary of the field.

You can set the A-B points either inside the boundary area or inside the field

area.

Setting the Headlands with Contour Pattern

During the job setup, select Headlands with Contour as the swath pattern.

Once the job is started:

1. Drive into the headlands area and press Begin Boundary.

2. Drive the boundary of the field. Viper records the path that you

drive around the boundary.

3. Press End Boundary when you have completed the first boundary

pass.

Helpful Hint: Viper will automatically close the boundary

when the vehicle is within one boom length from the Begin

Boundary set point.

4. Press Set A to start the first swath path.

5. Drive to the end of the first swath path and press Set B. The first

swath path is now set.

All consecutive swath paths are based on the original A-B swath path points.

You can also set a second B point if you plan to stop short of the headland

boundary. If you plan to drive outside of the headland boundary, the guid-

ance system advances automatically.

Abount Enable Snap

The Enable Snap option is available with the Headlands with Contour swath-

ing pattern. Before you can use the guidance system with this pattern for

pass guidance, you must press Enable Snap when you have finished driving

the headlands boundary.

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 341 342

No comments

Viper 2.08 Specifications Page 255