Viper Responder 350 Installation Guide download pdf (Page 13)

Valet/Program Switch, 2-Pin BLUE Plug

The Valet/Program button should be accessible from the driver’s seat. It plugs

into the BLUE port on the side of the unit. Since the system features Valet®

by using the remote transmitter, the button can be well hidden. Consider how

the button will be used before choosing a mounting location. Check for rear

clearance before drilling a 9/32-inch hole and mounting the button.The GRAY

wire in the two-pin plug may also be used as a (+) ghost switch input and can

be connected to any (+) switch in the vehicle. (See

Feature Descriptions

section of this guide.)

Programmer Interface, 3-Pin BLACK Plug

The BLACK three-pin port connection is for programming the unit.

When using the 998T Bitwriter®, it is possible to configure any and

all of the programmable functions. For more information please refer

to the guide packaged with the programmer.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Viper Responder 350 Installation Guide Page 13