Viper Responder 350 Installation Guide download pdf (Page 16)

Optional Sensor Harness, 4-pinConnector

The four-pin sensor harness is optional, and is not included with this unit.

RED (+) 12V Constant and BLACK (-) Ground

These wires supply constant (+) 12 volts and ground to the optional sensor.

BLUE/GREEN (-) Multiplex Input

These wires are multiplex inputs. If a (-) input of less than 0.8 seconds is

supplied to either wire, the Warn-Away response will occur. A (-) input of

longer than 0.8 seconds to either wire will initiate the triggered sequence and

report Zone 4.

Programming Jumper

Light Flash Jumper

This jumper is used to determine the light flash output. In the (+) position,

the on-board relay is enabled and the unit will output (+)12V on the WHITE

wire, H1/2. In the (-) position, the on-board relay is disabled. The WHITE

wire, H1/2, will supply a 200 mA (-) output suitable for driving factory

parking light relays.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

No comments

Viper Responder 350 Installation Guide Page 16