Viper Responder 350 Installation Guide download pdf (Page 8)

H1/6 BLUE (-) instant trigger input

This input will respond to a negative input with an instant trigger. It is ideal for

hood and trunk pins and will report on Zone 1. It can also be used with Directed

single-stage sensors. The H1/6 blue instant trigger wire can also be used to shunt

sensors during operation of auxiliary channels or remote start. (See

Bypassing

Sensor Inputs

section of this guide.)

H1/7 VIOLET (+) door trigger input

This type of dome circuit is used in many Ford products. Connect the violet

wire to a wire that shows (+)12V when any door is opened. This wire will report

Zone 3.

NOTE: If using a door trigger wire that has a delay, Advanced Menu 2, feature

6 or the 998T Bitwriter can be used to turn Bypass Notification off.

H1/8 BLACK (-) chassis ground connection

Connect this wire to a clean, paint-free sheet metal location (driver kick

panel) using a factory bolt that DOES NOT have any vehicle component

grounds attached to it. A screw should only be used when in conjunction with

a two-sided lock washer. Under dash brackets and door sheet metal are not

acceptable ground points. It is recommended that all security components be

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

No comments

Viper Responder 350 Installation Guide Page 8